Single figure basing.

[BaronVonWreckedoften]

Truly, madly, deeply....mad?

[tim.w]

So, got the washers but the hole? What to do with the hole? Thinking tape one side and fill with resin?

[levied troop]

Errrrr....doesn’t the figure’s little metal/plastic base cover that?

If not, whatever you’re using for ground filler will probably work, just smooth the underside off with your thumb.

[Count Belisarius]

I stick a small bit of sticky label over the hole and fill with glue when I stick the figure on... Then peel it off...

[Jeremy]

Sticky tape over the hole. Purps taught me that. Though in fairness he advised duct tape. And an old sock.

[Buff Orpington]

I have a never ending supply of sticky labels. Whenever we put reduced price stickers on stuff at work the printer only used the coloured label, there's a white one in between each one and that just goes in the bin. I salvage a few hundred every now and then.

[Peeler]

And 3mm deep

That's just far too deep for me.

[Timmo]

I either use PWS metal bases or 0.8mm ply from Litko. I just depends what size I want and if PWS does them.

[grizzlymc]

What is this single basing of which you speak. COTOTS says this is all preparation for the Fiery place.

[Buff Orpington]

Surely not, Angel Barracks did a lot of 60mm skirmish figures on single bases.