The Loose Association of Wargamers

Jeremy wrote: ↑Sun Apr 18, 2021 7:49 am So what’s on the braai today Simon? It’s a slippery slope...

Rat

with ketchup?

Buff Orpington wrote: ↑Sun Apr 18, 2021 8:05 am

Jeremy wrote: ↑Sun Apr 18, 2021 7:49 am So what’s on the braai today Simon? It’s a slippery slope...

Rat

I’m not sure it’s safe, the fuckers eaten a metric tonne of poison

FreddBloggs wrote: ↑Sun Apr 18, 2021 8:29 am with ketchup?

Onna stick

goat major wrote: ↑Sun Apr 18, 2021 8:53 am

Buff Orpington wrote: ↑Sun Apr 18, 2021 8:05 am

Jeremy wrote: ↑Sun Apr 18, 2021 7:49 am So what’s on the braai today Simon? It’s a slippery slope...

Rat

I’m not sure it’s safe, the fuckers eaten a metric tonne of poison

handy if you are on blood thinners, daily dose of wharfarin AND protein.

Shahbahraz wrote: ↑Sat Apr 17, 2021 11:19 pm Well - my second go failed as well. So it's back to re-levelling, and trying a different print. Fingers crossed again...

Hurrah! - suitably excited by my teeny tiny Cavalry Carrier... I wonder if there was an issue with the other stl file. Ok, now to have another go with a platform and some supports for the Kangaroo Ram hull again.

goat major wrote: ↑Sun Apr 18, 2021 8:53 amRat. I’m not sure it’s safe, the fuckers eaten a metric tonne of poison

Eat it anyway, you know Ebberston doesn't do metric.

Shahbahraz wrote: ↑Sun Apr 18, 2021 2:27 pm

Shahbahraz wrote: ↑Sat Apr 17, 2021 11:19 pm Well - my second go failed as well. So it's back to re-levelling, and trying a different print. Fingers crossed again...

Hurrah! - suitably excited by my teeny tiny Cavalry Carrier... I wonder if there was an issue with the other stl file. Ok, now to have another go with a platform and some supports for the Kangaroo Ram hull again.

Excellent! Looking forward to seeing the model painted and ready for action! Are you using your printer in the house and what resin are you using?

Hi Paul, I have the printer in a well ventilated room in the house. Basically what used to be our dining room, until it became my office. The resin is just the bottle that came with the printer, But I can see I am going to use this up in a matter of a few days, so I will have to do some research on the best resin for use with the Photon S. I am also going to have to get better at cleaning up the prints. (And making less mess.)

As it’s Neighpril, it made sense to do some test paints of my new Baron’s War figures