Page 1 of 2
Thicker girth around the shaft?
Posted: Fri Sep 02, 2022 10:52 am
by tim.w
Anyone know anywhere that does spears thicker than the usual wire spears?
Re: Thicker girth around the shaft?
Posted: Fri Sep 02, 2022 2:08 pm
by Jeremy
Northstar have various ones. Their long, steel ones are thicker than the copper ones
Re: Thicker girth around the shaft?
Posted: Fri Sep 02, 2022 2:21 pm
by FreddBloggs
have you tried existing ones with the pills they send you emails about?
Re: Thicker girth around the shaft?
Posted: Fri Sep 02, 2022 2:38 pm
by goat major
Essex do cast spears - they are most probably thicker than wire
Re: Thicker girth around the shaft?
Posted: Fri Sep 02, 2022 5:54 pm
by Essex Boy
You can buy brass rod in various thicknesses from good model shops. The shop under the city wall in York should have a selection. Just hammer the end flat and shape with a file. Or, piano wire....but with that a Dremel or similar would be rather handy.
E
Re: Thicker girth around the shaft?
Posted: Fri Sep 02, 2022 8:41 pm
by Zenbadger
Amazon do 1.5mm aluminium craft wire which I use when I am not using plastic bristles. Cut it to length, roll it on a flat board with a rough metal file (this straightens it and leaves a nice texture), crimp the business end flat with pliers and shape a point with a needle file or similar.
Re: Thicker girth around the shaft?
Posted: Sat Sep 03, 2022 1:49 am
by Etranger
Essex Boy wrote: ↑Fri Sep 02, 2022 5:54 pm
You can buy brass rod in various thicknesses from good model shops. The shop under the city wall in York should have a selection. Just hammer the end flat and shape with a file. Or, piano wire....but with that a Dremel or similar would be rather handy.
E
Piano wire is a lot harder (literally) to work with than brass. I managed to bugger up some good tools trying to cut & shape piano wire.
Re: Thicker girth around the shaft?
Posted: Sat Sep 03, 2022 10:51 am
by grizzlymc
And then, if someone leans on your spears, they stop leaning immediately.
Re: Thicker girth around the shaft?
Posted: Sat Sep 03, 2022 1:50 pm
by Essex Boy
Etranger wrote: ↑Sat Sep 03, 2022 1:49 am
Essex Boy wrote: ↑Fri Sep 02, 2022 5:54 pm
You can buy brass rod in various thicknesses from good model shops. The shop under the city wall in York should have a selection. Just hammer the end flat and shape with a file. Or, piano wire....but with that a Dremel or similar would be rather handy.
E
Piano wire is a lot harder (literally) to work with than brass. I managed to bugger up some good tools trying to cut & shape piano wire.
Very true. A Dremel (or similar) is your friend. A serious pair of pliers is also a must.
Personally, I prefer piano wire, because my terrible OCD makes me worry about brass rod bending.....which it does. Quite easily.
Re: Thicker girth around the shaft?
Posted: Sat Sep 03, 2022 2:37 pm
by FreddBloggs
Admit it your troops have piano wire, so once routed they can build a piano while the other players carry on the game.