What's on your workbench?

[BaronVonWreckedoften]

How shelfish....

A-ledge-edly.....

Took you a while to come up with that one?

Only just saw GM's original post.

[RMD]

I don't mind doing it, but I tend to break a lot of drill bits because I score with a knife and drill with a really fine bit, then with the proper sized one. And the really fine ones break very easily.

Yeah, I usually go with a very fine one first, but I've broken them all...

[Count Belisarius]

I'm still in full on rebasing mode...

20200330_205509_copy_1024x498.jpg (197.35 KiB) Viewed 3650 times

Soon I can start painting figures again...

[Essex Boy]

Alright, s'pose.

Are they the Welsh chaps?

[Wg Cdr Luddite]

I don't mind doing it, but I tend to break a lot of drill bits because I score with a knife and drill with a really fine bit, then with the proper sized one. And the really fine ones break very easily.

Yeah, I usually go with a very fine one first, but I've broken them all...

Are you drilling with a power tool ? Because I use small (< 0.7 mm)bits manually in a pin vice and hardly ever break them. Also I go straight for the correct sized bit because I find pilot holes not necessary.

[Shahbahraz]

They do look very splendid Count. I'm still working out how to base mine, but as I'm only playing skirmish style, I'm contemplating singles and sabot.

And Wingco, I usually do the pilot with a pin vice then dremel the proper sized hole. Especially on 15/18mm I destroyed too many hands.

[levied troop]

Those look very tasty Andy.

I've been going through the boxers and tidying things top -in this case a few big field/rough ground pieces that needed a better paint job and a good re-flocking:

[Shahbahraz]

What have pugilists to do with it? But those look like nice terrain pieces.

[RMD]

I don't mind doing it, but I tend to break a lot of drill bits because I score with a knife and drill with a really fine bit, then with the proper sized one. And the really fine ones break very easily.

Yeah, I usually go with a very fine one first, but I've broken them all...

Are you drilling with a power tool ? Because I use small (< 0.7 mm)bits manually in a pin vice and hardly ever break them. Also I go straight for the correct sized bit because I find pilot holes not necessary.

No, a hand-held one. I only had two tiny bits and broke them ages ago. Not got around to getting any more.

[levied troop]

What have pugilists to do with it?

Now everyone else would have taken my mistyping into the men’s nether garment territory.
But you sir, are a gentleman.